Art. No. SC 1000 KNX
i
A KNX channel is allocated to a room in the parameter node of the corresponding channel.
The channels can normally be allocated to one of the maximum 8 rooms. Hence, it is also
possible to allocate a channel to a room which is not visible on the room page, because it
was not created in the configuration of the rooms in the parameter node "Display ->
Rooms". In this case, the KNX channel concerned cannot be accessed via the room page!
It is generally recommendable to assign KNX channels only to rooms that are also
available in the room configuration.
When you touch the sensor surface of a channel with your finger, the device branches to the
submenu of the channel control (figure 18). All channels within the room view are activated by
selection operation. Functions must first be selected (1.). Afterwards, operations are performed
by means of the control command (2.).
To return to the room view, press the "
Z
<Room name>" icon (3.) in the status line at the top
edge of the screen.
Figure 18: Example of a selection operation in the room view - operating view (right)
Provided that a channel has been selected in the room by selection operation and the operating
view is displayed, it is possible to switch over to the other channels in the room by pressing and
pulling with your finger. After selecting a channel, it is therefore possible to switch over to the
other available channels in a room without having to make a detour to the room overview
(figure 19).
Page 72 of 347
Software "Smart Control 501511"
Functional description
