Jung J630D, Manual

Page: 47 / 316

J630D
2. Technical data / transportation / commissioning 26.7.02 41
2.7 Storage
2.7.1 Temporary storage
The following points should be noted in the event that the machine needs to be
stored temporarily prior to installation:
• Do not remove the machine from the packaging or crate.
• See transportation dimensions for storage dimensions.
• The permissible floor load must not be exceeded.
• The storage location must also fulfil the following requirements:
– Dry
– Under cover
– Protected against moisture condensation
– Storage temperature b10°C and +30°C
– Vibration-free
2.7.2 Installation
Installation requirements
• Note the permissible floor load.
• Connection and installation requirements. See section 2.1 “Technical data” on
page 25.
• Make sure sufficient floor space is available. See section 2.3 “Floor space dra-
wing” on page 29.
• Ensure adequate lighting.
• The machine must always be installed on a stable, level base. This base must
be free from extraneous vibrations and abrupt shocks of any kind.
• Keep the machine away from draughts as well as from hot air streams dischar-
ged by other machines.
• Do not expose the machine to direct sunlight.
If the machine is to be installed by Jung personnel, please store it in
accordance with the conditions described below.
Please heed the points listed below. They are essential in order to
ensure good grinding results and a long machine service life.