Jung J630D, Manual

Page: 25 / 316

J630D
1. Safety 26.7.02 19
Always observe the stipulated maintenance and servicing intervals. This applies
likewise to all optional equipment and to all intervals specified in the documenta-
tion of other manufacturers.
Check the machine for damage each time it is used. Check the protective devices
to make sure that they function both correctly and in accordance with their inten-
ded purpose. Never use a machine which is faulty or defective, nor a machine with
faulty or defective protective or safety devices.
Report all malfunctions, damage, defects, leaks and any other form of imperfec-
tion immediately to the person charged with overall responsibility for the machine.
Repairs must always be carried out either by K.Jung GmbH or by another
person or firm appointed and authorized by K.Jung GmbH.
Use only "original JUNG parts" when carrying out repair work.
Never use compressed air, high-pressure cleaners or aggressive detergents to
clean the machine. If grinding dust or dirt of any other kind is whirled up, it may
get into guides or bearings and cause them to wear out within a very short time.
Aggressive detergents may corrode and destroy the paint or other coating or the
safety plates.
Keep all grips, steps, railings, floors, windows and safety devices free from dirt
and other forms of contamination, such as coolant residues, oil or grinding dust.
Failure to do so may cause your view to be obstructed and / or result in slippery
surfaces.
If any error messages are displayed, you must rectify the fault first and then ack-
nowledge the message. Only then will you be able to continue working.
1.3.7 Disposal
Please consult the appropriate government agencies (e.g. the Refuse Depart-
ment) for all information regarding possible methods for disposing of wastes ge-
nerated during the service life of the machine (e.g. coolants, used oils, etc.).
Coolants, filter paper, grinding dust and used oil must be disposed of in an envi-
ronmentally compatible manner and in accordance with the relevant local statuto-
ry requirements.
1.3.8 Grinding wheels
When using grinding wheels, observe the accident prevention regulations and all
other statutory requirements valid in the country in which the machine is to be
used (BGV D12 in Germany). Heed all the instructions they contain.
Observe all the requirements specified by the wheel manufacturer.
Always use grinding wheels which comply with the European standard EN 12413
and which bear the following information as a minimum:
– Name of the manufacturer
– Type of bond
– Wheel dimensions
– Permissible peripheral speed and/or speed of the new wheel. Please note
the colour markings.