Jung J630D, Manual

Page: 191 / 316

J630D
5. Functions of the machine 26.7.02 185
5.10 Batch mode
If you select batch mode, you can link together up to 30 different programs in the
machining list to form one batch program. These machining cycles are then exe-
cuted in the batch program one at a time without any interruption..
5.10.1 Saving programs for batch mode
• Create any grinding or dressing program (see section 5.5 “Creating and mo-
difying grinding programs” on page 121 / see section 5.6 “Dressing” on
page 165).
• Press the "File" softkey in the "Program Jung" module (see section 5.1.6.2
“File manager” on page 89).
• Press the "Filemanag. save" softkey.
• Then select the hard disk (MMC).
– A list of the files on the hard disk (MMC) is displayed.
• Select the folder called "Batch1" and save your program under any name.
– To prevent name conflicts, please use an _ (underline) as the third character
of all batch program names.
• Load all the programs you want to combine in your batch program in the NCU.
– To do so, mark them and press the "Load NCU" softkey.
– These programs are then listed in the "Available batch programs" column
on the "Batch mode" screen.
5.10.2 Selecting batch mode
• Select the "Machine Jung" module (see section 3.1 “Control unit” on page 47,
position 12).
• Press the "Batch mode" softkey.
Please adhere to the following rule, in order to prevent name con-
flicts: use an _ (underline) as the third character of all batch program
names to differentiate them from other programs.
You should unload any programs you no longer need from the NCU
in order to ensure that you have sufficient free memory.
Every now and then you should also delete any programs you will
not need again from your hard disk (MMC) (see section 5.1.8 “Ser-
vice module” on page 95).