You can find further information about the eNet system on our website.
The device may be operated in all EU and EFTA countries.
Intended use
-
Switching of lighting
-
Operation with suitable eNet radio transmitters
-
Operation with power supply RMD and receiver module RMD cover or eNet server (see
accessories)
-
Installation in distribution boxes on DIN rail according to EN 60715
Product characteristics
-
Operating mode switch for switch/push-button actuator switch-over or parameterisation via
eNet server
-
Status feedback to radio transmitter
-
Scene operation possible
-
Switchable output with
Prog
button
-
Status indicator via LED
Switching mode of operation:
-
Switch-on telegram: Device switches on
-
Switch-off telegram: Device switches off
Operating mode buttons:
-
Relay contact remains closed as long as ON or OFF telegrams are being received
-
The maximum switch-on time is 60 seconds
Can be set with eNet server:
-
Flash function
-
Run-on time
-
Switch-on delay / switch-off delay
-
Operation as NO or NC contacts
-
Switch-off warning
-
Minimum switching repeat time
-
Operation locks
-
Continuous on, Continuous off
i
If settings are changed with the eNet server, operation and signalling could vary from what
is described here.
i
The parameter list is in the Internet in the documentation for this device.
Supplementary functions with eNet server:
-
Update of the device software
-
Reading of error memory
Behaviour in case of bus voltage failure and return
If the bus voltage fails, the actuator switches off. The response to bus voltage return can be
parameterised with eNet server. Default setting: Off.
4 Operation
Operation is with radio transmitters, please observe the radio transmitter instructions.
Operation with Prog button
o
Press
Prog
button briefly.
The load switches on or off.
Status-LED lights up: output is switched on.
Status-LED off: output is switched off.
2/11
82581713
J:0082581713
11.03.2014
eNet
Radio switch actuator for rail mounting, 1-channel