Art. No. DS 4092 TS
2.4 Commissioning
Programming the physical address
The commissioning of the device is basically confined to programming of the physical address
and the application program with the ETS.
Project design and commissioning of the device using ETS3.0 from Version "d" onwards, ETS4
from version 4.0.7 onwards or ETS5.
The device is connected and ready for operation.
An appropriate device must be created and configured in the ETS project.
o
Dismantle central plate(7) and control button (8) if the device has already been completely
mounted (figure 2).
o
Activating Programming mode: press the programming button (2).
The device indicates the programming mode with a pulsating tone (0.5 Hz) at maximum
volume.
o
Program the physical address with the help of the ETS.
Signal tone becomes silent.
Programming the application program
After programming the physical address, the application must be loaded into the device. The
ETS detects automatically whether a valid application has already been programmed into the
device before. To reduce the programming time, the ETS downloads the whole application only
if the device was programmed beforehand with another application or with no application at all.
In all other cases, the ETS makes a time-optimised partial download in which only the modified
data is loaded into the device.
Page 9 of 143
Installation, electrical connection and operation
