Temperature Management
Hygrostat
Ref.-no.:
..5201
HYG..
4. Operation
4.1. Setting the humiditiy manually
The center position of the control knob corresponds to approx. 55 %
relative humidity, which is generally considered just right for comfort.
The device must be in the automatic mode of operation.
The device has been enabled for free selection of the humidity with the
control knob (Fig. 3)
•
To increase the air humidity: turn the control knob to the right.
•
To reduce the air humidity: turn the control knob to the left.
L
When making changes, proceed only in small steps until the setting
for individual comfort has been found. As the air conditions in the
room change only slowly, the time between changes should be at
least 1.5 hours.
L
The relative humidity for comfortable room air conditions lies between
40 and 60 %.
4.2. Dehumidifying the ambient air manually
The device must be in the automatic mode of operation.
•
Depress the mode-of-operation selector briefly.
The relay is switched on for abt. one hour independent of the
degree of humidity in the room.
LED
yellow:
on
, LED
green:
on
, LED
red:
off
After an hour, the hygrostat switches back to the automatic mode of
operation.
4.3. Activating the party mode
The device must be in the automatic or in the manual mode of operation.
•
Depress the mode-of-operation selector twice briefly.
The relay is switched on for abt. six hours independent of the
degree of humidity in the room.
LED
yellow:
on
, LED
green:
on
, LED
red:
flashing
At the end of six hours, the hygrostat switches back to the
automatic mode of operation.
4.4. Activating the standby mode
The device must be in the automatic mode of operation.
•
Press the mode-of-operation selector longer.
After 3 s, the hygrostat switches the relay off for abt. 4 hours
independent of the degree of humidity in the room.
LED
yellow:
on
, LED
green:
off
, LED
red:
on
At the end of four hours, the hygrostat switches back to the
automatic mode of operation.
4
