Art. No. ..5192KRMTSD
Art. No. ..5194KRMTSD
4.2.4.1.2 Operation concept and button evaluation
The changeover between rockers and button operation of a control surface of the basic or
extension module is made on the parameter pages "TSM operation concept" and "TSEM
operation concept". The parameter page "TSEM operation concept" is only visible if an
extension module has been connected and enabled.
The parameter "Operation concept..." specify for each control surface whether the opposing
buttons are combined into a common rocker function, or are evaluated as two separate button
functions.
The additional parameter pages and the communication objects of the rockers or buttons are
then also created and adapted depending on the setting parameterized here.
i
Pressing several rockers or buttons at the same time will be considered as a wrong
operation. The special rocker function "Full-surface operation" is an exception to the above
rule. In this case, the parameterisation of the rocker decides whether the operation is a
wrong operation or not.
The functions of the individual rockers or buttons are set on the parameter pages "Rocker ...
(buttons ...)" or "button ..." "Button ...".
Button pair as rocker function
For rocker functions, the opposing buttons affect the communication objects together. As a rule,
actuation of the two buttons then result in directly opposite information (e.g. switching: ON -
OFF / blind: UP - DOWN). When a button is pressed, the commands should be made
independently of each other.
Full-surface operation with rocker function
Depending on the basic function of a rocker, it is also possible with some settings to use a press
on the full surface with a separate function. With full-surface operation, both buttons of a rocker
are pressed at the same time.
Button pair as button function
With button operation, the control surfaces are evaluated independently of each other (single-
area operation).
Page 86 of 309
Software "Room controller display compact module 146x11"
Functional description
