12
If a leakage from the battery occurs,
avoid touching it as it is corrosive. If
the liquid gets in contact with your
clothes, wash them with clean water. If it gets in
contact with your eyes, do not rub but wash
thoroughly under clean water and contact a
physician.
When charging your battery, make
sure the connectors are clean and free
of water or dirt before connecting the
charger.
The warning labels on the battery and
charger
present
important
information for your safety. Make sure
to follow the instructions carefully.
Turning the power on
Do not turn the power assist system on
before having mounted the bicycle
and being seated properly with at
least one foot on the ground. An unexpected
ignition of the power assistance while mounting
the bicycle can result in serious injuries.
This power assist system has an auto
shut off function. If there is no
operation or input from the controller
for some time, the LCD Display unit will shut down
automatically.
To turn the power assist system On:
1. First turn the battery power on
▪
Press the power button on top of the
battery. LED indicators will light up and
show battery charge level.
2. Then turn the LCD Display on
▪
Press and hold the controller’s Power
button for 2 seconds. LCD Display will
power up.
Always turn the battery on before
turning the LCD Display on. LCD
Display will not power up if the battery
power is not turned on before.
If the error logo shows up when the
LCD Display lights up do not ride your
bicycle. Contact a qualified dealer to
have your power assist system
checked.
Using the controller
Position the controller facing up, next to
your grip so you can reach it with the
thumb.
▪
Press and hold Power button for 2
seconds to turn the LCD Display On or
Off.
▪
Short press Power button
for 1
second to switch LCD Display mode
(current
speed,
average
speed,
maximum
speed,
trip
distance,
odometer, time…).
▪
Press Up button
to switch power
assistance mode to a higher level.
▪
Press Down button to switch power
assistance mode to a lower level.
▪
Press and hold Down button
for 2
seconds to switch to Walk mode from
any mode. Walk mode will instantly shut
down once you release the button.
▪
Press and hold down the button for 2
seconds to turn on or off the backlight.
▪
Press and hold down the
and
buttons simultaneously for 2 seconds to
reset the max speed, average speed, trip
time and trip distance.
Switching to Walk mode will instantly
ignite the motor and propel the bicycle
to a speed of 5 km/h even with no
pressure on the pedals. Make sure you are holding
your bicycle steadily and that the path in front of
your bicycle is clear. Walk mode will automatically
shut down once you release the button.
Summary of Contents for Rapid-E
Page 1: ......
