JUMO TYA S202, Operating Manual, Page: 15 / 99

V1.00/EN/00709725 [Thyristor power controller TYA S202] 15
1 Introduction
1.5 Standards, approvals, and conformity
Device properties are inspected on the basis of the Low Voltage Directive DIN
EN 50178.
The EMC directive is inspected on the basis of DIN EN 61326-1.
Standard
Electrical connection DIN VDE 0100
Protection type IP20 built-in devices DIN EN 60529
Climatic ambient conditions Class 3K3
Air temperature and rel. humidity DIN EN 60721-3-3
Storage temperature class 1K5 DIN EN 60721-3-1
Operating conditions
Pollution degree
Overvoltage category DIN EN 50178
2
III
Test voltages DIN EN 50178
Residual current circuit breaker DIN EN 50178
Electromagnetic compatibility
Interference emission
Interference immunity DIN EN 61326-1
Class A - only for industrial use
Industrial requirement
Mechanical tests:
Vibration test 3M2
Toppling test class 2M1
DIN EN 60068-2-6, DIN EN 60721-3-3
DIN EN 60068-2-31, DIN EN 60721-3-2
Labels, identification marking DIN EN 50178, DIN EN 61010-1
Approvals Standard Type
UL 508 (Category NRNT), pollution degree 2
C22.2 NO. 14-10 Industrial Control Equip-
ment (Category NRNT7) 709066/X-XX-020-...
Load current 20 A
UL 508 (Category NRNT)
C22.2 NO. 14-10 Industrial Control Equip-
ment (Category NRNT7) 709066/X-XX-032...
709066/X-XX-050...
709066/X-XX-100...
709066/X-XX-150...
709066/X-XX-200...
709066/X-XX-250...
Load current
32 to 250 A
Can be used for electrical circuits with a short-circuit current capacity of
≤
100 kA (the admissible mains voltage must correspond to the nominal voltage of
the thyristor controller).
For plant protection, a fuse up to class RK5 may be used.
CE conformi-
ty Low Voltage Directives 2006/95/EC
Marking Directives 93/68/EEC
EMC Directives 2004/108/EC