JUMO LOGOSCREEN 500, Operating Instructions Manual

Page: 38 / 100

3 Operation and visualization
36
3.5 Event list
Events Various events can initiate texts which are included in the event list and saved
in the internal memory or on diskette. Events may include:
- alarms triggered by out-of-limit conditions on individual channels,
- external texts triggered through logic inputs,
- system messages (e. g. power ON/OFF, summer/winter time changeover),
Event
definition Foll all events, except for system messages, it is possible to configure whether
- the message text is to be included in the event list,
- the standard text internal to the instrument
- or one of the texts (see below) is used.
Text
assignment The texts (standard texts or 18 freely definable texts) are assigned to the
events at the operating level “Configuration”
(
v
Chapter 4 “Configuration parameters”).
Freely definable
texts 18 texts can be freely defined, up to a length of 20 characters.
Standard texts The instrument offers standard texts as listed in the following table:
Standard text Note
Chan x low alarm ON
Chan x low alarm OFF
Chan x high alarm ON
Chan x high alarm OFF
Alarm counter/int. x ON
Alarm counter/int. x OFF
Logic input y ON
Logic input y OFF
Logic channel y ON
Logic channel y OFF
x = channel number
y = input number
Counter x : y x = counter channel number
y = counter value (9 digits)
Power ON
Power OFF
Data lost
Summer time start
Summer time end
New configuration
Counter/int.
x from y reset to z
x = counter/int. channel number
y = old counter/int. value (9 digits)
z = new counter/int. value (9 digits)
„Text 1 — 18“ 18 freely definable texts
with 20 characters each