JUMO flowTRANS MAG I02, Operating Manual

Page: 55 / 88

55
8 Startup and parameterization
8.6.12 Configuring the digital input DI1
The digital input DI1 allows one of the four following functions to be triggered remotely:
INPUT DI1 DISABLE The digital input is not used with
this option.
CALIB.0 Configure the digital input to re-
motely trigger the calibration of the
flow zero point. The calibration can
also be performed in the test
menu,

see "Configuring the dig-
ital input DI1 to trigger flow rate
zero point calibration ", page 56.
HOLD Configuring the digital input to
freeze the flow rate measure-
ments,
 see "Configuring the dig-
ital input DI1 to trigger calibration
for the device's HOLD
mode ", page 57.
SET FLOW Configuring the digital input to con-
trol the status of the outputs and
the display depending on a flow
rate replacement value,
 see
"Configuring the digital input DI1 to
switch from a measured value to a
replacement value ", page 58.
HOLD TOT. Configuring the digital input to
freeze the counters,
 see "Con-
figuring the digital input DI1 to
freeze the counters ", page 59.
RES.TOT Configuring the digital input to re-
set the daily counter,

see "Con-
figuring the digital input DI1 to
reset the daily counter ", page 60.
RETURN