JUMO exTHERM-DR, Operating Manual, Page: 56 / 100

9 Configuration level
56
9.6 Analog/logic output
Parameters Comment
Value range
(default setting in bold)
9.6.1 Function This setting specifies the signal that should be output at the
analog output. Measured value,
Setpoint value,
Logic output
Measured value:
The value measured at the analog input is output.
Setpoint value:
The setpoint value is output.
Logic output:
With this setting, the switching status of the relay output
controller K1 or limit value K2 is also output as a binary sig-
nal 0/10V.
The output now no longer functions as an analog output.
This is set in Chapter 9.6.6.
The relay outputs retain their switching function.
9.6.2 Signal type 4 to 20 mA 4 to 20 mA,
0 to 20 mA
2 to 10 V
0 to 10 V
0 to 20 mA
2 to 10 V
0 to 10 V
9.6.3 Scaling start
v
Figure in Chapter 9.6.7 -9999 to -200 to 9999
9.6.4 Scaling end
v
Figure in Chapter 9.6.7 -9999 to 800 to 9999