JUMO exTHERM-DR, Operating Manual, Page: 49 / 100

9 Configuration level 49
9.3 Controller
Parameters Comment
Value range
(default setting in bold)
9.3.1 Control direction Inverse: heating function
If the measured value is below the setpoint value + hysteresis,
relay output controller K1 switches on.
If the measured value exceeds the setpoint value, the relay
switches off.
(2) Hysteresis w Setpoint value
Inverse, direct
Direct: cooling function
If the measured value exceeds the setpoint value + hysteresis,
relay output controller K1 switches on.
If the measured value is below the setpoint value, the relay
switches off.
(2) Hysteresis w Setpoint value
X
Y
4
1
¾
"5
4
1
¾
"5
Y
X
4
1
¾
"5
4
1
¾
"5