JUMO dTRANS CR 02, Operating Manual, Page: 32 / 120

6 Operation
32
✱
Select "USER LEVEL".
All possible parameters are accessed below. Depending on the configuration
of a specific instrument, some of these parameters may not appear.
6.6.1 Parameters of the User level
See chapter 16.2 "Parameters of the User level", page 105.
6.7 Administrator level
- All the parameters can be edited at this level.
- At this level, it is also possible to define which parameters can be edited by
a "normal" user (operator) and which calibrations can be performed.
To get to the Administrator level, proceed as follows:
✱
Press the key for longer than 2 seconds.
✱
Use the or keys to select "ADMINISTR.-LEVEL".
✱
Use the and keys to enter the password 300 (factory setting).
✱
Confirm the key.
6.7.1 Parameter level
The settings that can be made here are the same as those at the User level,
see "User level", page 31. As the operator (user) has administrator rights here,
the parameters that are locked in the User level can now also be modified.
6.7.2 Release level
All parameters can be released (modification possible) or locked (no
modification possible) for editing at the User level.
6.7.3 Basic setting
The JUMO dTRANS 02 CR has a basic setting wizard, to make it easier for the
user to configure the extensive setting options of the instrument and to avoid
configuration conflicts.
The basic settings are reached via ADMINISTR.-LEVEL/PASSWORD/BASIC
SETTING.
All the important settings are systematically polled here. At the end, once a
request for conformation has been acknowledged, the instrument is initialized
with the new settings. Dependent parameters are checked and adjusted.
PGM
PGM