JUMO digiLine CR HT10, Operating Manual, Page: 57 / 84

57
12 IO-Link data
12.2 Configuration data
The configuration is stored in the parameter manager and is transferred via the IO-Link interface in an
acyclic process.
Process data output 1 (process values as TFLOAT)
Designation Data type Value range Default Description
Measuring range
selection TUINT8 0x00 = MR 1
0x01 = MR 2
0x02 = MR 3
0x03 = MR 4 -
Compensation
temperature TFLOAT - -
Process data output 2 (process values as TINT32)
Designation Data type Value range Default Description
Measuring range
selection TUINT8 0x00 = MR 1
0x01 = MR 2
0x02 = MR 3
0x03 = MR 4 -
Compensation
temperature TFLOAT - - Compensation temperature ac-
quired by IO-Link master for trans-
fer to the JUMO digiLine CR
This process value must be trans-
ferred after multiplication by a fac-
tor of 10.
General information
Designation Index Sub-
index
Data type Value range Default Ac-
cess
right
a
a
RW = Read and write access
RO = Read access only
WO = Write access only
Description
Data format 64 0 TENUM
(1 byte) 0 = Floating point
1 = Integer Float-
ing
point RW
Standard com-
mand 2 0 Button 0x82 = Reset to de-
fault setting - WO The default
data is load-
ed.