JUMO digiLine CR HT10, Operating Manual, Page: 51 / 84

51
11 Data overview
11 Data overview
11.1 General Information
Information about the device and its process/operating data is stored in the JUMO digiLINE electronics.
This information can be viewed using the JUMO DSM software.
The operating data includes signals such as alarms, measured values and sensor monitoring data. The
measured values can be displayed and the status of sensor operation observed using the JUMO DSM
software.
11.2 Sensor data
The sensor data provides an overview of sensor characteristics and settings. No data can be edited
here.
Data point Explanation
Manufacturer's data
Device name Type information as well as software and hardware version of the JUMO dig-
iLineCR
Software version of the main proces-
sor
Software version of the input proces-
sor
Hardware version
Sensor type
Article information on the sensor mounted on the JUMO digiLine electronics
is entered in these fields by the manufacturer during production. The data are
displayed in the JUMO DSM software. In the Modbus mode, these data can
also be retrieved for viewing only. The user can refer to these data when re-
ordering.
Sensor subtype
Manufacturers
Customer order number
VK job number
Part no.
Customer type
Order code
Customer item number
Customer number
Serial number
Hardware address
Date of manufacture
Cal. status
Sensor information
Minimum ambient temperature These fields hold data on the sensor type currently in use.
Maximum ambient temperature
Minimum medium temperature
Maximum medium temperature
Minimum conductivity
Maximum conductivity
Maximum pressure at 25 °C
Material in medium
Material not in contact with medium
Process connection
Tests / approvals
Cell constant