JUMO digiLine CR HT10, Operating Manual, Page: 38 / 84

7 Operation
38
7.2 Device menu
The device menu is opened from the measuring mode by pressing the "OK" operating key. The sub-
menus listed in the following table are available here.
To navigate through the menu hierarchy, use the "Up" and "Down" operating keys to move the cursor to
the submenu you wish to open. You can recognize the position of the cursor by the inverted appearance
of the highlighted menu entry. Pressing the "OK" operating key opens the submenu marked by the cur-
sor. Arrow symbols (pointed brackets) at the end of the line after menu entries indicate that additional
submenus are available. If the number of menu entries in a menu exceeds the number of display lines,
a scroll bar appears at the right edge of the display.
Submenu Explanation
Log-on/Log-out The user logs on and out here. In addition, passwords can be changed here.
 chapter 7.2.1 "Log-on/Log-out", page 39
Calibration Functions for calibrating the JUMO digiLineCRwith the currently connected sensor

chapter 7.2.2 "Calibration", page 39
Device informa-
tion Information on device hardware and software.
 chapter 7.2.3 "Device information", page 39
Service Functions and information on diagnosis and maintenance of the device hardware
 chapter 7.2.4 "Service", page 40