JUMO DICON touch, Operating Manual, Page: 97 / 196

97
12 Configuration
12.6.7 Controller setpoint values
With this separate setpoint value function, the setpoint values and the ramp function can be
configured flexibly for each of the control channels (Controller 1 to 4).
Up to four setpoint values are available for each control channel and can be switched using two
digital signals.
The analog signal for the setpoint specification (external setpoint value 1 to 2) is selected from
the analog selector. A correction value (setpoint value 1 to 4) can be applied to this signal. If no
analog signal is selected (inactive), the correction value acts as a fixed setpoint value.
Setup dialog box
Parameters
NOTE!
The active setpoint value is not automatically used as a setpoint value for the control channel;
it must first be assigned in the controller configuration (see Chapter 12.6.2 "Controller inputs",
page 82).
NOTE!
If an analog signal is used as a setpoint value without a correction value, it can also be directly
assigned in the controller configuration. In this case, setpoint value limitation, setpoint
changeover, and the ramp function are not available.
Equally, a fixed setpoint value can be assigned directly in the controller configuration (see
Chapter 12.6.2 "Controller inputs", page 82).
Parameter Selection/settings Description
Signal for ext. setpoint
value No function Signal source for ext. setpoint value.
Analog selector
External setpoint value No correction No ext. setpoint value correction takes place