7 Startup
46
Implementing the basic settings
✱
Use the
and
keys to enter the value for "SALINITY" and confirm with
the
key.
✱
Enter the values for "AIR PRESSURE", "UNIT" (select "mg/l"), and "SAM-
PLING RATE" using the
and
keys and confirm each using the
key.
✱
For the "TEMPERATURE SENSOR" request, select "MODBUS" and con-
firm with the
key.
Initializing the device
✱
Use the
or
key to respond to the next question "REINITIALIZE
DEVICE?" with "YES" and confirm with the
key.
Accessing the parameter level
Like the "BASIC SETTINGS", the "PARAMETER LEVEL" is a submenu in the
administrator level. After successful sensor initialization, the device display will
already be in this level, or you can navigate to it as described above.
Final device settings / inspections
RS485 input
Device address:
255
Salinity:
As entered in "Basic settings"
Air pressure:
As entered in "Basic settings"
Sampling rate:
As entered in "Basic settings"
Filter time constant:
As needed
Calibration interval:
As needed
Zero point:
Calibration value
Slope:
Calibration value
Temperature
input
Temperature sensor:
Modbus
Unit:
°C
Filter time constant:
2 s
Offset:
0.0 °C
Analog output 1
Signal selector:
Main value
Signal type:
4 to 20 mA
Scaling start:
0.00 mg/l
Scale end:
20.00 mg/l
For calibration:
As required
NOTE
When using the type 202613 sensor, the temperature offset setting affects the
displayed temperature, the analog outputs and the limit values. It does not,
however, affect the temperature compensation inside the sensor.
Summary of Contents for AQUIS 500 RS
