JUMO AQUIS 500 RS, Operating Manual, Page: 36 / 120

6 Operation
36
6.9 Controller functions
Simple switching functions
In the JUMO AQUIS 500, simple switching functions such as alarm contact,
limit value monitoring, or calibration timer signaling are configured in the
parameter level using the "Switching output 1" or "Switching output 2" para-
meters.
Higher order control functions
Higher order control functions (P, PI, PD, and PID behavior) are configured in
the parameter level using the "Controller 1" or "Controller 2" parameters.
If the limit value, pulse length, pulse frequency, and three-step controller types
are used, the switching outputs must be configured; if the continuous control-
ler is used, the analog outputs must be configured.
Example of parameters in the operator level
Switching output 1 or 2 Explanation
None Neither switching nor control function required
Controller 1 The device should use "higher order" control
Controller 2 The device should use "higher order" control
Controller alarm 1 or 2 "Simple" switching function
Controller alarm "Simple" switching function
main value (Alarm function 1) main value
main value (Alarm function 2) main value
main value (Alarm function 7) main value
main value (Alarm function 8) main value
temperat. (Alarm function 1) temperature
temperat. (Alarm function 2) temperature
temperat. (Alarm function 7) temperature
temperat. (Alarm function 8) temperature
Sensor error
Washtimer
Calib. timer
Controller channel 1 or 2
Limit
Pulse width
Pulse frequency
Continuous
Modulating
"Higher order" control functions