JUMO AQUIS 500 RS, Operating Manual, Page: 32 / 120

6 Operation
32
CONTROLLER CHANNEL 1 or CONTROLLER CHANNEL 2
CONTROLLER TYPE
SETPOINT
SETPOINT 2
MIN/MAX CONTACT
PROPORTIONAL BAND
RESET TIME
DERIVATIVE TIME
PULSE PERIOD
ACTR.STROKE TIME
HYSTERESIS
MIN. ON TIME
MAX. PULSE FREQ.
OUTPUT LEVEL LIMIT
PULL-IN DELAY
DROP-OUT DELAY
CONTROLLER ALARM
ALARM TOLERANCE
ALARM DELAY
IN HOLD MODE
HOLD OUTPUT LEVEL
ON ERROR
MAX. SETPOINT
MIN. SETPOINT
CONTROLLER SPEC. FUNCT. (controller special function)
I SWITCH-OFF
SEPARATE CNTRLR:
MANUAL MODE
SWITCHING OUTPUT 1 or SWITCHING OUTPUT 2
FUNCTION
SWITCHING POINT
PRE-ALARM
SPACING
HYSTERESIS
SWITCH-ON DELAY.
SWITCH-OFF DELAY.
PULSE TIME
FOR CALIBRATION
IN CASE OF FAULT
IN HOLD MODE
MANUAL MODE
NC / NO CONTACT
ANALOG OUTPUT 1 or ANALOG OUTPUT 2
SIGNAL SELECTOR
SIGNAL TYPE
SCALING START
SCALING END
DURING CALIBRATION
ON ERROR