"Using a programmer" menu
34
2.13.2018
6.
"Using a programmer" menu
Select in the main menu
.
Setpoint = green
Actual value = red
A programmer makes it easy to quickly program setpoint
temperature profiles. A profile is a series of temperature setpoints.
A profile consists of several individual steps. Each step is defined
according to a length of time (t:) or gradient (°/t) and target
temperature.
The target temperature is the setpoint that will be reached when
the step is complete. The programmer references time and temper-
ature difference in a step to calculate a temperature ramp (1).
Attention:
If the time specification is too short, there will not be enough time to
reach the setpoint. The programmer contains an easy way to
handle this situation.
If a step time of 00:00:00 is entered, the setpoint will "jump" (2) to
the target temperature as quickly as possible.
The profile will continue with the next step only after reaching the
specified temperature (±0.2 °C).
Eight profiles with up to 60 steps each can be stored.
The
Standard
and
Gradient
settings can be used together in a
single profile.
Edit Profile:
Create or edit a temperature profile.
Start Profile:
Start a temperature profile
.
Use programmer series
:
This feature allows you to set a
series so a certain profile will run at
the same time on several different
days.