JUKI SC-956, Instruction Manual

Page: 17 / 185

– 12 –
❹
❺
❷
B
❸
A
❶
1. If the screw is excessively loos -
ened, the spring will come off.
Loosen the screw to such an extent
that the top of the screw can be
observed from the case.
2. Whenever you have adjusted the
screw, be sure to secure the screw
by tightening metal nut
❺ to pre -
vent the screw from loosening.
1) Fix connecting rod ❶ to installing hole B of
pedal lever ❷ with nut ❸ .
2) Installing connecting rod ❶ to installing hole
A will lengthen the pedal depressing stroke,
and the pedal operation at a medium speed
will be easier.
3) The pressure increases as you turn reverse
depressing regulator screw
❹
in, and de-
creases as you turn the screw out.
2-12. Attaching the connecting rod
2-13. Adjustment of the pedal
❷
❹
❷
❶
❸
2-13-1. Installing the connecting rod
2-13-2. Adjusting the pedal angle
Move pedal ❸ to the right or left as illustrated by
the arrows so that motor control lever
❶
and con-
necting rod ❷ are straightened.
1) The pedal tilt can be freely adjusted by
changing the length of the connecting rod ❷ .
2) Loosen adjust screw ❹ , and adjust the
length of connecting rod ❷ .
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and a lapse of 5 minutes or more.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.