– 7 –
2-3. Installing the solenoid valve
3) Fit the rubber sheet in place and secure solenoid
valve
.
1) Remove the rear cover of the table stand.
2) Detach the metal plate (second from the left) from the manifold.
There is a rubber sheet between the metal plate and the manifold.
Setscrew
4) Pull out the connectors from the electrical control
box. Insert the cables of solenoid valve
into
the connectors .
Insert the red cable into the connector No. 1.
Insert the black cable into the connector No. 3 .
Put the cables in the duct for wiring. Connect
the connectors to the corresponding ports of the
electrical control box.
1 2
3 4
1
4
Rear cover of the table stand
metal plate
