JUKI PLC-2760NVM, Instruction Manual

Page: 23 / 42

– 21 –
15. Tension correction
❽ ❾
❹ ❼ ❻ ❺
<Sewing data edit screen>
2) Press ❷ to proceed to the next page.
Press
❸
.
The "S113 Needle thread tension correction
screen" is displayed.
<Sewing screen (Maintenance personnel mode)>
❶
<S113 Needle thread tension correction screen>
1) Press ❶ on the sewing screen under
the maintenance personnel mode.
The "sewing data edit screen" is displayed.
❸ ❷
3) Select the thread tension correction method
you want to use from the four methods de-
scribed below:
❹
Not use
❺ Sewing speed (initial setting)
❻ Bobbin thread remaining amount
❼ Both (the sewing speed and the bob-
bin thread remaining amount)
4) Select the type of the tension correction data.
・
In case of correcting the tension in accor-
dance with the sewing speed.
Select the chart number you want to save
from among 1 to 4 with ❽ .
Then, press ❾ .
Refer to "15-1. Tension correction and
sewing speed" p.22 for the steps of
procedure after the above.
・ Press when you want to correct
the thread tension in accordance with the
remaining amount of bobbin thread.
Refer to "15-2. Tension correction and
remaining amount of bobbin thread"
p.23 for the steps of procedure after the
above.
* Press to confirm the data you have
entered and return the screen to the "Sewing
data edit screen".