– 8 –
7. LUBRICATION
(1) Lubricating procedure for the face plate
portion
1) Loosen and remove screw
A
.
2) Open the face plate in the direction of
arrow mark
B
.
3) Apply an adequate amount of oil once a
day to the points marked with the arrow
marks.
4) Close the face plate.
5) Tighten and attach screw
A
.
(2) For other parts
1) Apply an adequate amount of oil once a day to
the points marked with the arrow marks.
2) Before you operate your machine for the first
time, or after an extended period of disuse, apply
an adequate amount of oil to the points marked
with the arrow marks and to each felt and oil wick
after removing top cover
❶
.
(Caution) If oil is filled more than required, oil leak
-
age may result.
(3) Insert the projection located at the bottom of oil
tank
❷
into the waste oil hole of the oil pan.
(4) Insert oil pipe
❸
into filter
❹
of the oil tank and fix
the pipe with a clip.
(5) Pour the JUKI New Defrix Oil No. 2 into the oil
tank
❷
until HIGH level is reached.
(6) Add the same lubricating oil up to HIGH level
as soon as the oil level has come down to LOW
level.
(7) After the lubrication, you can see from oil sight
window
❺
that the oil rises up when the opera-
tion is normal. (However, the machine should run
at 1,500 sti/min or more.)
❶
❺
❸
❹
❸
❹
❷
B
A
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
