JUKI LK-1900B/IP-420, Instruction Manual

Page: 89 / 144

– 85 –
[ Folder structure of the media ]
Store each file in the folders below of the media.
Data that are not stored in the directories above cannot be read. So, be careful.
26-2 Performing communication by using the media
1) Turn the label side of the CompactFlash(TM)
to this side (place the notch of the edge to the
rear. ) and insert the part that has a small hole
into the panel.
2) After completion of setting of the media, close
the cover. If the cover cannot be closed since
the memory media comes in contact it, check
the following:
・ Check that the media is securely pressed
until it goes no further.
・ Check that the inserting direction of the
media is proper.
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the CompactFlash (TM).
3. The media slot in the IP-420 accommodates to the CompactFlash (TM) of 2 GB or less.
4. The media slot in the IP-420 supports the FAT16 which is the format of the CompactFlash (TM).
FAT32 is not supported.
5. Be sure to use the CompactFlash (TM) which is formatted with IP-420. For the formatting procedure
of the CompactFlash (TM), see "26-3 Performing format" p.88 .
Media
■ Inserting the CompactFlash (TM)
Media drive
Store sewing standard data.
Store vector format data.
SD00 . DAT
SD00 . DAT
VD00 . VDT
VD00 . VDT
Vector format data :
Store in ¥VDATA.
Sewing standard
format :
Store in ¥SDATA.
VDATA
SDATA