– 115 –
32. PERFORMING KEY LOCK
①
Display the key lock screen.
In the state where the power is turned OFF, turn
the power ON by turning ON the DIP switch 1-1
on the MAIN PCB.
When
key is held pressed for three
seconds, KEY LOCK button
A
is displayed
on the screen. When this button is pressed down,
the key lock setting screen is displayed.
The existing setting status is displayed on the key
lock button.
: Key lock non-setting status
: Key lock setting status
A
B
C
* In the case the DIP switch 1-1 on the MAIN PCB
is in the OFF state, the "key lock button" is not
displayed on the mode screen.
②
Select the key lock status and determine.
Select KEY LOCK STATUS button
B
in
the key lock setting screen, and press
C
. Then the key lock setting screen is closed and
the key lock status is obtained.
Summary of Contents for LK-1900B/IP-420
Page 5: ... 1 1 NAME OF EACH SECTION OF THE OPERATION PANEL 1 1 Body Front Right side ...
Page 12: ... 8 3 2 Sewing screen A B C F N E D O P R Q G J M K H I L ...
Page 43: ... 39 15 2 Sewing screen A D E F C H R I G L M N Q O P B S V J K T U ...
Page 56: ... 52 21 2 Sewing screen B A C D S U W T Q R V E O J H I P M N K F X G L ...
