– 47 –
This sewing machine can perform continuous stitching which is capable of continuously sewing plural
sewing pattern data without lifting the presser foot. It is possible to automatically sew up to maximum 6
shapes in one cycle.
In addition, registration of as many as 20 data can be performed. Copy and use the data to fill the needs.
→
Refer to
"V-14. Copying sewing pattern" p.43
* It is necessary to change the parts from the state at that time of your purchase according to the
setting conditions.
(1) Selection of continuous stitching data
1) Set the mode to the input mode.
Under the input mode where SET READY LED
goes out, the continuous-sewing data selection is
enabled.
If the current mode is the sewing mode, press
READY key
❷
to change over the mode
to the input mode.
Only under the input mode, the continuous-sew-
ing data selection is enabled.
2) Select continuous stitching.
Press ITEM SELECT key
❻
to select the
continuous-sewing screen
A
.
Press DATA CHANGE key
❼
to select the
continuous-sewing data No.
B
to be sewn.
3) Perform sewing.
When READY key
❷
is pressed in the
state where the continuous-sewing data is select-
ed, SET READY LED
lights up to show that the
sewing is enabled.
Continuous stitching data No. 1 only has been
registered at the time of your purchase. Howev-
er, sewing status cannot be obtained since the
sewing pattern has not been inputted. Perform
inputting of sewing pattern referring to
(2) Method
of editing continuous stitching data
on the next
page.
17. Performing continuous stitching
A
B
❼
❻
❷
