63
Performance Check list
If sewing difficulties occur, make sure the instructions are correctly followed.
If a problem still exists, the reminders below may help to solve it.
Problem
Cause (Reason)
Action to be taken
Page
Machine fails to
feed fabric.
* Machine runs idle.
* Stitch length is set at left position of manual mode.
* Drop feed is engaged.
* Return bobbin winder to the left.
* Set stitch length at auto mode or right position of manual mode.
* Disengage drop feed.
14-16
26,27
13
Needle breaks.
* Needle is bent. Needle is not correctly installed.
* Presser foot does not match pattern selected.
* Relation among needle, thread and fabric is not appropriate.
* Change needle with a new one and install it correctly.
* Use presser foot that matches the pattern selected.
* Use needle and thread that match fabric.
21
22
24
Thread breaks.
* Machine head is incorrectly threaded.
* Thread is caught in a part that is not to be threaded.
* Needle thread tension is too high.
* Needle is bent.
* Re-thread machine head correctly.
* Check spool pin and thread guide for thread tangling.
* Adjust thread tension adequately.
* Replace needle with a new one.
17-19
-
23
21
Bobbin thread
breaks.
Skipped stitches.
* Needle is not installed correctly.
* Needle is bent.
* Machine head is not correctly threaded.
* Correctly attach needle.
* Replace needle with a new one.
* Re-thread machine head correctly.
21
21
17-19
Puckering occurs.
* Thread tension is too high.
* Needle and thread do not match fabric.
* Adjust thread tension adequately.
* Use needle and thread that correctly match fabric.
23
24
Thread tangles on
wrong side of fabric.
* Machine head is not correctly threaded.
* Re-thread machine head correctly.
17-19
Loud noise, heavy to
turn the hand wheel.
* Lint or dust has accumulated in hook.
* Clean up hook.
62
Sewing machine will
not sew when start
button is pressed.
* Bobbin winder is set in bobbin winding position.
* Foot controller is connected to machine.
* Return bobbin winder to the left.
* Start machine with foot controller or remove connector from
machine.
14-16
11
Needle cannot be
threaded.
* Needle is not raised to its highest position.
* Needle is not installed by fully inserting into needle clamp.
* Sewing machine is rotated by mistake with needle threading
lever lowered (during needle threading).
* Turn handwheel to raise needle to its highest position.
* Correctly install needle.
* Turn handwheel slightly away from you (in direction opposite to
normal direction of rotation in which handwheel turns to perform
sewing).
18
21
-
Specification table
Item
Specification
Dimensions
415 (W) x 300 (H) x 190 (D) mm
Dimensions with case
440 (W) x 305 (H) x 215 (D) mm
Weight
7.1kg (with case: 8.2kg)
Rated voltage/ Power consumption
120V / 0.62A 60Hz (USA and Canada only)
220-230V / 65W 50 / 60Hz
Acoustic noise level
less than 70 db(A)
Summary of Contents for HZL-K65
Page 5: ...4 MEMO ...
Page 67: ...66 MEMO ...
