– 8 –
) The standard heght of the presser foot lfted usng the knee lfter s 0 mm.
2) You can adjust the presser foot lft up to 3 mm usng knee lfter adjust screw
1
.
3) When you have adjusted the presser foot lft to over 0 mm, be sure that the bottom end of needle bar
2
n ts lowest poston does not ht presser foot
3
.
1
2
3
WarNING :
Be sure to turn the power oFF before the following work in order to prevent personal injury due to
unintentional starting of the sewing machine.
6. adjusting the height of the knee lifter
7. Installing the thread stand
2
1
) Assemble the thread stand unt, and nsert t n
the hole n the machne table.
2) Tghten nut
1
.
3) For celng wrng, pass the power cord through
spool rest rod
2
.
