– 8 –
3-10. Raising the machine head
WARNING :
Tilt/raise the sewing machine head with both hands taking care not to allow your fingers to be
caught in the head.
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
[When using areas 1306 and 1510]
When raising the sewing machine, hold inserting
section
A
of the machine bed by hand, and quietly
raise it until bed support rubber
3
comes in contact
with the table. For the S type, remove chain
2
from
manual pedal
1
first, and perform the work.
1. Be sure to raise the machine
head at the leveled place so as
to prevent the sewing machine
from falling.
2. When raising the machine
head, move feeding frame
4
beforehand to the right-hand
side until it goes no further, and
fix it with tape or the like. When
the machine head is raised in
the state that moving or fixing is
insufficient, breakage of X-move
cover or X-move rail will be
caused. Besides, feeding frame
4
which is tilted to the left-hand
side by the self-weight interferes
with the intermediate presser
or the like and breakage of the
components will be caused.
4
2
3
6
5
A
1
7
[Area 2206]
[When using area 2206]
1) Remove throat plate auxiliary cover
6
from the sewing machine.
2) Hold inserting section
A
of the
machine bed by hand, and quietly
raise it until bed support rubber
3
comes in contact with the table.
3) After returning the sewing machine
to its home position, refer to
Installing the throat plate auxiliary
cover”
, and install the throat plate
auxiliary cover.
1. Be sure to raise the machine head at the leveled place so as to prevent the
sewing machine from falling.
2. When raising the sewing machine without removing throat plate auxiliary cover
6
,
the throat plate auxiliary cover interferes with the table, bend or breakage of the
throat plate auxiliary cover, tilt of the sewing machine, etc. will result.
