6
JUDO EASY FILT-BP
Product information
3.
Product information
3.1
Intended purpose
This domestic water station is suitable for
use in cold drinking water up to a maximum
water temperature of 30 °C (86 °F).
This domestic water station is used in
drinking water installations for filtering and
reducing the pressure of drinking water.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
Please refer to the chapter on “Intended
use” for use restrictions.
This domestic water station is used to
protect the water pipes and hot water heater
against limescale deposits.
This domestic water station removes coarse
and fine-grained particles from the water
which are larger than or equal in size to the
mesh size of the domestic water station.
3.2
Materials used
The materials used are resistant to the
physical, chemical, and corrosive loads to
be expected in the drinking water and fulfil
the requirements specified in the DIN EN
13443-1, DIN 19628 (“Mechanical filters in
drinking water installations”) and DIN EN
1567 standards (“Building valves - Water
pressure reducing valves and combination
water pressure reducing valves”). All mate-
rials are hygienically and physiologically
safe. Plastics fulfil the official guideline of the
German Federal Environmental Agency as
well as the DVGW work sheet W 270.
Metallic materials fulfil the requirements of
the DIN 50930-6 standard (Impact on the
drinking water quality).
4.
Installation
4.1
General
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
The unit may only be installed by skilled
personnel.
The chapter on “Intended use” must always
be observed!
The pipes must be able to safely support the
domestic water station.
Otherwise mechanical damage or fractures/
bursts can occur in the pipes. This can result
in major water damage. People close to the
domestic water station are exposed to a
health risk due to the large quantities of
water released. Therefore, if necessary, the
pipes must be additionally fixed or
supported.
For convenient operation and maintenance
it is absolutely necessary to ensure the
given spacings.
A space of at least 200 mm should be main-
tained above and below the domestic dater
station. These distances are necessary to
be able to properly carry out the back-
washing and maintenance work (see chap-
ters “Backwashing” and “Modifications /
changes / spare parts”).
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.