Page 6
1.
Judge advise the use of
appliance descaler, available from all
good multiples. Follow the directions
given to prepare a solution in 1 litre of
water and pour into the empty water
tank
2
.
2.
Follow the steps as in “Before first
use” to descale as follows:
• Use 1/3 of the solution to descale the
filter system; rest for 10 minutes.
• Then use 1/3 of the solution to descale
the steam system; rest for 10 minutes.
• Again use 1/3 of the solution to
descale the filter system; set all
switches to OFF.
3.
Rinse out the water tank and fill with
fresh water and repeat the above
procedures. This will thoroughly clean
through the system, ensuring your
coffee maker will last the test of time.
Troubleshooting
A.
The coffee maker does not supply
hot water.
1. Check there is sufficient water in the
Water Tank 2 and it is seated properly.
2.
There may be an air-lock in the water
system. Repeat the ‘Before first use’
instructions.
• If this is not effective, the coffee
maker should be returned to Judge
at the address given in the Warranty
section.
3.
No steam: when the machine is
unplugged and cool, remove and clean
the Steam Nozzle
4
. Check there is
sufficient water in the Water Tank
2
and it is seated properly.
• If this is not effective, the coffee
maker should be returned to Judge
at the address given in the Warranty
section.
small brush can be used to clear any
remaining grounds, and the holder
can then be rinsed under a cold tap.
The centre filter of the pod holder may
be gently levered out to gain access
to the small hole in the flow control
spacer in the centre of the holder; if
it is clogged, it may be cleaned with
a pin, then replace the centre filter.
Check that the rim of the pod holder is
clean and will seat perfectly.
Steam nozzle
• Hold the black rubber sleeve on the
Steam Nozzle
4
and turn clockwise
which will unscrew the complete
lower part of the steam tube.
• Wash this assembly under running
water.
• Reassemble by gently screwing back
on anti-clockwise.
Water tank
• Periodically remove the Water Tank
2
, clean the inside with a cloth or
sponge, rinse and replace. Check that
the water control valve in the base
of the tank is operating properly -
water should flow smoothly when the
central plunger of the valve is pushed
upwards.
Periodic de-scaling
To ensure the lasting quality of
your espresso maker it is important
to regularly de-scale the system. It is
suggested to run this procedure every 2
months for hard water areas and up to 6
months for soft water areas:
Cleaning (Continued)
