- 56 -
Range of values: [19V,24V], and the range is generally set above 22.2V for 6S
batteries, and when the battery is low, the corresponding protection action is triggered,
and actions such as disable, LAND and RTL can be set;
The secondary protection
Range of values: [19V,24V],the voltage values of the secondary protection shall not be
larger than that of the primary protection, and the range is generally set above 21.6V
for 6S batteries, and when the battery is extremely low, the corresponding protection
action is triggered, and actions such as disable, LAND and RTL can be set;
3.3.17.2 Remote
When the output PWM value of Throttle of remote is smaller than the set value, it
implements the set actions to make sure that UAV is controllable;
PWM values can be set between 925 and 1100;
For the implementation of actions, the tasks can be continued in the modes of disable,
RTL, LAND and AUTO mode.
3.3.17.3 Data disconnect
（
5S
）
triggering actions
You can set that, if UAV doesn't receive any actions that the signal of ground control
station implements within specific times (5 seconds in most cases), you can select
disable or RTL.
Note: when UAV is of [AUTO], for the ground control station under fault protection, it
can be set as invalid RTL, and UAV will continue to cruise according to the set route.
3.3.18 Geographical rail
➢
Control the flying area of UAV
1) Check "enable" to enable the rail protection
2)Rail type: you can set rail height, radius rail, radius and height rail, or no rail, to
restrict the flying area of UAV.
3)Action: implement actions after it goes beyond the rail scope, and you can choose to
report "crossed the border" or implement two actions, that is, RTL or LAND;
4)maximum height: restrict the maximum flight height of UAV;
5)maximum radius: restrict the maximum flying radius of UAV;
6)Minimum RTL height: set the minimum RTL height of UAV (regardless of whether the
