35
13.7
MON1 MON2 Analog monitor outputs (CN1-11~12)
These output signals are for monitoring the dynamic states of the servo drive and can be selected in
the
“
Common Parameter
”
menu, in which the scale, offset and resolution of the output signals are also
defined
MON1: as Monitor Channel A defined the
“
Common Parameter
”
menu;
MON2: as Monitor Channel B defined the
“
Common Parameter
”
menu
13.8
Encoder output signals (CN1-19~24)
Encoder output signals, derived from the servo drive, can output to an external Host Controller. The
Host Controller then uses these signals in its control circuit.
Summary of Contents for YPV-040
