JRC JMR-7210-6X, Instruction Manual

Page: 269 / 586

24-37 Section 24 Specifications
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
付録
24.37 NKE-1696
GENERAL SPECIFICATION NKE-1696-9
Dimension Height 507 × Swing Circle 2810 (mm)
Mass Approx. 58kg
Polarization Horizontal
Horizontal beam width: 0.8
°
Vertical beam width: 20
°
Side lobe level:
below -26dB (within
±
10
°
)
below -30dB (outside ± 10 ° )
Revolution Approx. 24 rpm
Power Supply for Motor
100 to 115VAC, 50/60Hz 1 φ or 220 to 240VAC, 50/60Hz 1 φ
Maximum Wind Velocity 51.5m/s (100kt)
Transmitting Frequency P0N(9410MHz), Q0N(9440±4MHz) or (9435MHz±4MHz)
Transmitting Power
Peak-to-peak value 600W ± 50% (Average value 5.8W or lower)
Transmitting Module Solid State Device
TX Pulse width (1st) /
(TX Pulse width, Frequency Deviation Width
(2nd)) / Repetition Frequency
(Observation Range)
SP1:
0.07μs/(4.6μs, 8MHz)/
1360Hz or 1700Hz
(0.125NM, 0.25NM, 0.5NM, 0.75NM, 1.5NM, 3NM, 6NM, 12NM)
MP1:
0.14μs/(
4.6
μs, 8MHz)/
1360Hz or 1700Hz
(0.75NM, 1.5NM, 3NM, 6NM, 12NM)
MP2: 0.28
μs/(9.1μs, 8MHz)/1
000Hz
(1.5NM, 3NM, 6NM, 12NM)
LP1: 0.56
μs/(9.1μs, 8MHz)/1
000Hz
(3NM, 6NM, 12NM, 24NM)
LP2: 1.12
μs/(
9.1
μs, 8MHz)/
660Hz or 730Hz
(3NM, 6NM, 12NM, 24NM, 48NM, 96NM)
Duplexer Circ Diode Limiter
Frond End Module Built-in
Overall Noise Figure 4.5dB (typical)
Performance Monitor Built in
Intermediate Frequency Amplifier
Intermediate Frequency 63MHz
Band Width 30MHz
Amplifying Characteristics Linear Amplifier
GENERAL SPECIFICATION NKE-1696-6
Dimension Height 507 × Swing Circle 1880 (mm)
Mass Approx. 53kg
Polarization Horizontal
Horizontal beam width: 1.2 °
Vertical beam width: 20
°
Side lobe level:
below -26dB (within ± 10 ° )
below -30dB (outside ± 10 ° )
Revolution Approx. 24 rpm
Power Supply for Motor
100 to 115VAC, 50/60Hz 1 φ or 220 to 240VAC, 50/60Hz 1 φ
Maximum Wind Velocity 51.5m/s (100kt)
Transmitting Frequency P0N(9410MHz), Q0N(9440±4MHz) or (9435MHz±4MHz)
Transmitting Power
Peak-to-peak value 600W ± 50% (Average value 5.8W or lower)
Transmitting Module Solid State Device
TX Pulse width (1st) /
(TX Pulse width, Frequency Deviation Width
(2nd)) / Repetition Frequency
(Observation Range)
SP1:
0.07μs/(4.6μs, 8MHz)/
1360Hz or 1700Hz
(0.125NM, 0.25NM, 0.5NM, 0.75NM, 1.5NM, 3NM, 6NM, 12NM)
MP1:
0.14μs/(
4.6
μs, 8MHz)/
1360Hz or 1700Hz
(0.75NM, 1.5NM, 3NM, 6NM, 12NM)
MP2: 0.28
μs/(9.1μs, 8MHz)/1
000Hz
(1.5NM, 3NM, 6NM, 12NM)
LP1: 0.56
μs/(9.1μs,
8MHz)/1000Hz
(3NM, 6NM, 12NM, 24NM)
LP2: 1.12
μs/(
9.1
μs, 8MHz)/
660Hz or 730Hz
(3NM, 6NM, 12NM, 24NM, 48NM, 96NM)
Duplexer Circ Diode Limiter
Frond End Module Built-in
Overall Noise Figure 4.5dB (typical)
Performance Monitor Built in
Intermediate Frequency Amplifier
Intermediate Frequency 63MHz
Band Width 30MHz
Amplifying Characteristics Linear Amplifier