Z2 Controller Operations Manual
Interoperability Now
5-15
Z2C Installation and Operation Manual
Figure 5-12: Basic Channel Settings, USB Headset
Channel Profiles
are very useful for Radio Channels in the RSP-Z2, but they have limited utility
in the Z2 Controller. For headsets, the automatic USB Headset settings are normally preferred.
However, profiles operate in the same manner as with the RSP-Z2. See the RSP-Z2 Installation
and Operation Manual located under
Help
for full information about profiles.
5.3.1
USB Headset Settings
The USB Headset requires only a few settings options, and the USB headset default settings
should be appropriate in most circumstances. Note that the USB headset must be plugged in
prior
to the Z2C system being powered on for the channel to be made available.
The USB Headset has two COR Types, VOX (as shown below) and PTT. The
COR Type
determines what type of control signal will indicate that a valid audio signal is present. This is
important because whenever COR is active, the headset audio will be retransmitted from all Z2C
channels that the headset is cross-connected with.