Joyner TROOPER T2, Owner'S Manual, Page: 71 / 205

71
4.4.
Rotate camshaft a round, keep the position
as the right figure, measure the clearance
again.
If exceed the standard of valve clearance,
replace a adjusting washer to get a proper
clearance
Attention: record the position where valve
clearance exceed the standard and the
result
4.4.1. Rotate camshaft to make the cam-top
(valve clearance exceed the standard)
upwards, and gap of valve lifter towards
inside.
4.4.2. Rotate camshaft and the cam press valve
lifter down.
4.4.3. Load the special tool at the top of the
valve lifter around the valve lifter, and then
rotate camshaft to make the cam-top
upwards, press valve lifter down with a
special tool, and hold it.
4.4.3.1. Move the adjusting washer out with a
screwdriver, and then remove the
washer with a magnet iron wire from
inside.
4.4.3.2. Use a caliper to measure and adjust the
thickness of the separation cushion.
First
cylinder
Second
cylinder
Third
cylinder
Fourth
cylinder
IN EX IN EX IN EX IN EX
— — — O O — O O