Joyner TROOPER T2, Owner'S Manual, Page: 67 / 205

67
2.7. Camshaft
2.7.1. Use the caliper to measure the height of
the camshaft. If it is below the specified
limits, make roper replacement.
Camshaft Unit ： mm
Model
EF
Item
ZL
、
RL
GL
、
GS
、
ZS
Standard
IN
φ 23.0-0.02 -0.033
EX
φ 23.0-0.02 -0.033
Limit
IN
φ
22.9
EX
φ
22.9
2.7.2. Checks on camshaft axial clearance
(1)
、
When the axial spacing is measured with a
clipper to be larger than the benchmark value,
the camshaft is to be replaced. The air inlet
camshaft axial clearance is 0.1
～
0.170mm
。
The
air exhaust camshaft axial spacing is 0.1
～
0.173mm
。
Limits for operation
：
0.18mm
2.7.3. Checks on camshaft meshing clearance
(1). Put camshaft into cylinder head
(2). Make sure the front mark on bearing cover
and shaft number is ok, and then tighten bolt.
(3). Fix air inlet camshaft, and then measure the
clearance with dial indicator.
Attention: measure 4 points around gear
·use a special tool to rotate air inlet camshaft.
·under the condition that the mark on drive-gear
match the mark on driven-gear
3. Installations
3.1.
When using a special tool
3.1.1. Fix the two φ 6 holes of the camshaft gear S/A.
3.1.2. Turn the slave gear to the right, match the mark hole
on the slave gear with the mark on the master gear, or
align the marks on the slave gear with the mark on the
master gear; then fix the slave gear with bolt.(Thread:
M5; pitch: 0.8)
Fixer
Bolt