Joyner TROOPER T2, Owner'S Manual

Page: 66 / 205

66
2.3.2. Use bolt to position the master and slave
gears on the air inlet camshaft, as shown
in the right figure.
Attention
In order to eliminate the radial force,
keep the camshaft in the leveled position before
dismounting it (to avoid possible damages
caused by excessive radial forces)
2.4.
Remove bolts according the right figure,
remove camshaft bearing cover
2.5.
Remove the spark plug
2.6.
Remove the camshaft slave gear.
2.6.1. Use the special tool as shown in the right
figure.
Clip the camshaft tightly, and turn the gear, to
keep the bite state of master and slave gear;
remove the fixing bolts of slave gear.
Attention:
Do not damage the surface of the
camshaft.
2.6.2. Don’t Use the special tool
(1). Screw bolt M6 on the camshaft slave gear as
the right figure show
(2). Rotate the gear with a screwdriver; remove
the bolt fixing slave gear
Attention:
Do not damage the surface of the
camshaft.
(3). Remove retainer for shaft with tensionor,
remove waveform washer, driver ring and saddle
flip washer.
Screw
Bolt
Fixer