8.8 MODEM OPERATION
The GI-2000 controller can be remotely accessed via a modem for the purpose of remote
configuration setup and grease level data monitoring.
This requires an external modem and cable that is supplied by Josam.
To activate the modem capability DIP Switch Position 1 must be set. (See Figure 8.1.2-2
for the Dip Switch location).
If the modem option is set on controller power ON Activity LED 1 will flash three (3) times
indicating the modem was found and initialized by the controller. Activity LED 1 will then
remain on to indicate the controller has the modem option enabled.
If the modem option is enabled but the controller could not successfully initialize the
modem the following message will appear:
INIT MODEM FAILURE
Note:
Activity LED 1 will then remain on to indicate the controller has the modem option
enabled, however proper modem operation will not be achieved unless the Activity LED 1
has flashed three (3) times.
8.9 RECLAIM TANK DISPLAY
The GI-2000 controller will display following message whenever a full reclaim tank is
detected:
-RECLAIM TANK FULL-
RECLAIM TANK MUST BE
EMPTIED BEFORE NEXT
CLEAN CYCLE CAN RUN
GI-2000 Manual V2.3
Page
39