Jonsered BLT58VJN, Operator'S Manual

Page: 11 / 296

LED lights Battery status
All Green LEDs
come on
Fully Charged (100% - 76%)
LED 1, 2 and 3
come on
The battery pack is 75% - 51%
charged.
LED 1 and 2
come on
The battery pack is 50% - 26%
charged.
LED 1 comes on The battery pack is 25% - 6%
charged.
LED 1 flashes The battery pack is 5% - 0% charg-
ed.
Note: If the motor stops and the power LED stays on,
push the button on the battery pack. For possible
solutions, see
TROUBLESHOOTING on page 12
.
Note: When the battery pack is fully discharged, the
motor stops immediately.
Note: The motor automatically stops if the battery pack
or motor controller is too hot during heavy operation. Let
the motor and battery pack cool. The product then
resets.
To operate the grass trimmer
• Clean the cover of the trimmer head when you
attach a new trimmer line to prevent vibrations.
• Examine other parts of the trimmer head and clean if
it is necessary.
To trim the grass
• Hold the trimmer head immediately above the
ground at an angle.(Fig. 24 )
• Do not push the grass trimmer line into the grass.
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 25 )
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
4. Use full throttle when you move the product from
side to side to cut grass. Make sure that the grass
trimmer line is parallel to the ground. (Fig. 26 )
MAINTENANCE
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Daily maintenance
• Remove the battery pack. Refer to the operating
instructions of the battery pack for correct
maintenance.
• Examine the nuts, screws and bolts.
• Examine the trigger for correct operation.
• Examine the power button for correct operation.
• Remove external unwanted material from the
product with a soft brush or dry cloth. Do not clean
with water, cleaning fluids, or solvents.
• Use a soft brush to remove unwanted material from
the air vents.
• Examine the product for missing, damaged, loose or
worn parts.
• Examine the product to make sure the moving parts
align and are safe for operation.
• If the product is damaged, speak to an approved
service center. Do not use a damaged product.
To replace the trimmer line
1. (Fig. 27 )
2. (Fig. 28 )
3. (Fig. 29 )
4. (Fig. 30 )
5. (Fig. 31 )
6. (Fig. 32 )
7. (Fig. 33 )
8. (Fig. 34 )
667 - 002 - 18.05.2018 11