15
I25
I24
I23
I22
I21
I20
I19
I18
I17
I16
I15
I14
I13
I12
I11
I10
I9
I8
I7
tr
it
fr
es
en
de
Blade on the outer radius
Cleaning or replacing the float (Indication for full recovery tank)
Disassembly:
Assembly:
Squeegee settings
If you experience an uneven suction result, the settings of the suction unit
should be corrected. Proceed as follows:
Before carrying out the adjustment, check that:
• the blades are not damaged (replace).
• the suction unit is not damaged.
Height setting (Fig. A)
• First check the distance between the floor and the running or support
wheels.
The distance between running wheels number 1 and 2 and the floor must be
between 1 mm and 3 mm in each case (with the blades standing vertically).
The distance between support wheel number 3 and the floor must be 6 mm
(with the blades standing vertically).
• Switch the machine off using the keyswitch and then lower the squeegee.
• To correct, loosen the hexagonal nuts number 1 and 2, and then adjust the
height by turning the Allen screw. Then firmly re-tighten the hexagonal nuts
Number 1 and 2.
• Check the result while cleaning (see illustration below) and go to "Angle of
Inclination" (Fig. B) if the result is unsatisfactory.
Angle of inclination(Fig. B)
• Switch the machine off.
• Lower the squeegee and move the machine forward by a few centimetres
so that the blades can adopt their working position.
• To correct, loosen Allen screw number 4 and adjust the angle of inclination
by turning Allen screw number 5.
Note: Carry out the correction with gradual adjustments!
Firmly retighten Allen screw number 4 after the correction has been made. Then
move the machine forward by a few centimetres and check the setting of the
scraper edge that has been achieved. Repeat this procedure until the correct
inclination is obtained.
Caution:
Danger of injury from clamping the fingers!
• Lock the metal strap (Check position of mounting slots) into place and press
the centre of it until it ”clicks” into place and presses the blade onto the
squeegee body (Risk of injury).
• Turn the squeegee upside down by placing it on its suction hose connector
and the bumper wheels.
• Loosen the clamping screw of the blade fastener by using an allen key (4).
• Release the metal band and pull the blade off the squeegee body.
• Clean squeegee (body, metal straps and blades) with a brush.
• Mount the "turned" or the new blade on the nozzle body, so the creases
point outward.
• Hook the metal strap into place (Check position of mounting slots) and fix it
with the screwdriver until the blade is pressed onto the squeegee body.
The shape of the blades allow them to be used on all sides before needing
replacement.
• Switch the machine off using the keyswitch and remove the key.
• Hold the float and pull it over the lower stopper.
• Clean it with water using a brush (let it dry out well).
• Brush the yellow suction filter with a soft brush
or remove the fluff with a cloth.
The yellow suction filter can be easily removed
(quick-fit seal).
• Hold the float at its small diameter. Push it over
the lower stopper until it clicks into place.
• Check:
-that the float easily moves up and down.
-that the float completely covers (seals) the yellow suction filter.
A correct angle has been achieved when the tip
of the rear blade (x) is distributed over the
complete width of the suction unit.
1
2
3
A
B
4
5
x
x
5
4
