Johnson JET 6000, Service Manual

Page: 44 / 62

INCLINE MOTOR REPLACEMENT
(JET6000)
Tools required:
ü
Philips screwdriver
ü
Wrench (14mm)
ü
Wrench ( 17mm)
Procedure:
1. Remove screws from
the front cover by using
the screwdriver to open
the cover.
2. Disconnect cables from the connectors of the incline
motor and MCB and also disconnect the ground wire.
3. To prevent the frame from falling down heavily while
removing the incline motor, put a support with
proper height under the front of frame.
4. Remove the bolts and the nuts from the incline motor by
using the wrenches (14, 17).
5. Replace the incline motor with a new one.
6. Reconnect cables and the grounding wire to the
connectors and the frame.
7. Remove the support under the frame.
8. Turn on the power and enter the Engineering Mode to
check if the extreme inclines are within the correct
range.
9. Install the front cover and secure the screws.
7-3 Revision: 1.0 Date: 2001-06-01