Johnson EP703, Service Manual, Page: 8 / 28

5
CHAPTER 3
：
CONSOLE INSTRUCTION
TO RESET THE CONSOLE: Hold STOP key for 3 seconds.
FINISHING YOUR WORKOUT:
When your workout is complete, the monitor display will flash “FINISHED” and beep. Your workout
information will stay displayed on the console for 30 seconds and then reset.
CLEAR CURRENT SELECTION: To clear the current program selection or screen, hold the STOP button for 3 seconds.
USING YOUR CD / MP3 PLAYER / BLUETOOTH SPEAKERS:
1) Connect the included AUDIO ADAPTOR CABLE to the AUDIO IN JACK on the top right of the console and the headphone
jack on your CD / MP3 player.
2) Use your CD / MP3 player buttons to adjust song settings.
3) Remove the AUDIO ADAPTOR CABLE when not in use.
4) If you don’t want to use the SPEAKERS, you can plug your headphones into the AUDIO OUT JACK at the bottom of the
console.
5) To connect to the Bluetooth speakers open your Bluetooth settings, turn on Bluetooth, scan for new devices, look for Horizon
7.0AE and select connect.
3.4 Program Information
1) Manual: Control everything about your workout – from start to finish. This program is a
basic workout with no pre-defined settings,allowing you to manually adjust the machine at any time.
It begins with a resistance at 1.
2) Distance:
Push yourself and go further during your workout with 13 distance workouts.
Choose from 1 mile, 2 miles, 5k, 5 miles, 10k, 8 miles, 15k, 10 miles, 20k, half marathon, 15 miles,
20 miles, and marathon goals. You set your level.