background image

© 2015 Johnson Health Tech. All Rights Reserved. Specifications subject to change without notice.

Rev 1.0

MAGNUM  SERIES

MG-A690-05 / HALF RACK

MAINTENANCE CHECKLIST

ACTION

FREQUENCY

Clean Upholstery *

Daily

Inspect Cables

Daily

Clean Guide Rods

Monthly

Inspect Hardware

Monthly

Inspect Frame

Bi-Annually

Clean Machine

As Needed

Clean Grips *

As Needed

Lubricate Guide Rods †

As Needed

* Upholstery & Grips should be cleaned with a mild soap and water or 

a non-ammonia based cleaner.

† Guide rods should be lubricated with Teflon based lubricant. Apply the 

lubricant to a cotton cloth and then apply up and down the guide rods.

PRODUCT SPECIFICATIONS

TECH SPECS

Maximum User Weight

181.5 kg / 400 lbs.

Maximum Training Weight

408.5 kg / 900 lbs.

Product Weight

A690-05 (8ft)

A690-9-05 (9ft)

195 kg / 430 lbs.

202 kg / 445 lbs.

Overall Dimensions (L x W x H)*

A690-05 (8ft)

A690-9-05 (9ft)

166.5 x 187 x 256.5 cm /

65.5” x 73.5” x 101”

166.5 x 187 x 287 cm /

65.5” x 73.5” x 113”

Weight Horn Diameter  

(Weight Plate Storage)

47.63 mm / 1.875”

* Ensure a minimum clearance width of 0.6 meters (24”) for access to 

and passage around MATRIX strength equipment. Please note, 0.91 

meters (36”) is the ADA recommended clearance width for individuals 

in wheelchairs.

WARRANTY

For North America, please visit 

www.matrixfitness.com  

for warranty information along with warranty exclusions  

and limitations.

PROPER USAGE

1.  Do not exceed weight capacity of this 

equipment.

2.  If applicable, set safety stops to 

appropriate height.

3.  If applicable, adjust seat pads, leg 

pads, foot pads, range of motion 

adjustment, or any other type 

of adjustment mechanisms to a 

comfortable start position. Make 

certain that the adjusting mechanism is 

fully engaged to prevent unintentional 

movement and to avoid injury.

4.  Sit on bench (if applicable) and get into 

appropriate position for exercise.

5.  Exercise using no more weight than 

you can safely lift and control.

6.  In a controlled manner, perform 

exercise.

7.  Return weight to its fully-supported 

start position.

Summary of Contents for Matrix MG-A690-05

Page 1: ...x 73 5 x 101 166 5 x 187 x 287 cm 65 5 x 73 5 x 113 Weight Horn Diameter Weight Plate Storage 47 63 mm 1 875 Ensure a minimum clearance width of 0 6 meters 24 for access to and passage around MATRIX strength equipment Please note 0 91 meters 36 is the ADA recommended clearance width for individuals in wheelchairs WARRANTY For North America please visit www matrixfitness com for warranty informatio...

Page 2: ... use of the equipment by a person responsible for their safety 3 All warnings and instructions should be read and proper instruction obtained prior to use Use this equipment for its intended purpose ONLY 4 Inspect the machine before use DO NOT use machine if it appears damaged or inoperable 5 Do not exceed weight capacity of this equipment 6 ALWAYS use a spotter if using free weights 7 Balance the...

Page 3: ... 8 washers and 8 3 8 lock nuts attach the spotter stands to the bases and torque all bolts to 30 ft lbs 2 Place lower base support and bases where the machine is to be used Using 4 3 8 16 x 1 bolts and 4 3 8 washers attach base support to bases and torque all bolts to 30 ft lbs 3 Attach each upright to the base using 8 3 8 16 x 1 bolts and 8 3 8 washers Do not tighten bolts STEP 1 STEP 2 STEP 3 ...

Page 4: ...Upright support Using 4 3 8 16 x 1 bolts 4 3 8 16 x 5 bolts 12 3 8 washers and 4 3 8 nuts attach the upright support to the bottom of the upright and the base Do not tighten bolts 7 Chin bar Using 8 3 8 16 x 4 bolts 16 3 8 washers and 8 3 8 16 nuts attach the chin bar between the tops of the 2 rear uprights Do not tighten bolts 8 Tighten bolts Starting with the bottom of the uprights and working y...

Reviews: