Johnson Controls YORK OM Titan, Operating Instructions Manual

Page: 33 / 138

JOHNSON CONTROLS
33
FORM 160.72-O1 (810)
overvieW
This screen displays the major components as well
as the temperatures, pressures, and outputs for the oil
pump compressor lubrication system. In addition, this
screen allows manual control of the auxiliary oil pump
for up to 10 minutes.
displaY onlY
next oil seal lubrication
Displays in minutes when the oil seal will be lubri-
cated.
Thrust Bearing pressure
Displays the oil pressure at the thrust bearing as mea-
sured by a transducer, if available.
shaft pump discharge pressure
Displays the oil pressure supplied to the filter as mea-
sured by the output of the shaft oil pump.
filter pressure
Displays the pressure differential between the Shaft
Pump Discharge pressure transducer and the Post Fil-
ter Pressure transducer in the oil line after the filter.
CoMpressor luBriCaTion sCreen
COMPRESSOR LUBRICATION SCREEN figure 8 -
post filter pressure
Displays the pressure of the oil being supplied to the
compressor after the filter.
shaft pump pressure
Displays the pressure differential between the Shaft
Pump Discharge pressure transducer (input to the fil-
ter) and the Sump Pressure transducer in the compres-
sor housing.
sump pressure
Displays the low side oil pressure measured at the sump
in the compressor housing.
supply pressure
Displays the pressure differential between the high
side oil pressure transducer (output of oil filter) and
the low side oil pressure transducer (sump compressor
housing).
Main oil Temperature
Displays the temperature of the main oil supply being
supplied to the compressor, after the oil cooler.
3