Johnson Controls tyco iSTAR Ultra, Installation And Configuration Manual

Page: 70 / 118

Access Control Module
5–4 iSTAR Ultra Installation and Configuration Guide
Figure 5-2: ACM Right Side- Sections 1 and 8
The various user visible controls, connectors and displays are shown. Sections 1 and 8 are
indicated on most of the components. The jumper technique for wet or dry relays is shown on
the left.
The power connector labeled Reader is used for the reader and the logic.
The next 2 sets are not shown, but are identical to Figure 5-3.
Figure 5-3 on page 5-5 shows the other end of the ACM and locates the USB connector, ACM
Reset, and some of the LED locations. Sections 4 and 5 are shown.